Setting up a Brick Paver Walkway or Red Clay Bricks

The usage of Bricks or Pavers to produce a pathway or patio area matches a home in a method that is unequaled. In addition, installing a Brick or Paver sidewalk does not necessarily need a pro.

The key to installing a Brick or Paver Walkway is to very first properly prepare the location where the bricks/pavers are to be set up. The location should be removed a minimum of a foot down, getting rid of all topsoil and clay soil. In addition, string lines must be strung on each side of the pathway. The string lines indicate the finished height of the walkway.
Once the location has actually been dug down, 3/4" gravel stone need to be laid in and tamped down firmly. Then 2" of sand, or stone dust need to be topped the gravel. Again the sand/stone dust need to be tamped down. Stone dust is chosen. The height in between the tamped down sand and the stringline ought to equal the density of the brick or paver.

Now that you have a stable base, place a 1" pipe or ledger board the length of the walkway on either side of the walkway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level surface location to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Install a work on both sides of the prepared area. These strips will function as your walkway border and help to preserve the stability and shape of the walkway. You can get these plastic strip borders at a lot of house improvement shops. The strips ought to be anchored down with 12" galvinized nails. You must sink these nails into the ground and through the strips every foot.

The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will once again help preserve the stability of the pathway.

Undoubtedly bricks/pavers will need to be cut or split when building the walkway. To in fact cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the spot where you desire to break the brick. If your pathway has curves you will need to buy/rent a wetsaw.

After installing the bricks, develop the outdoors edges with extra sand, and then shovel in the topsoil and pack down strongly.
Lastly, spread stone dust over the new pathway and sweep into the fractures. Repeat this procedure a couple of times to make sure the fractures are totally filled. This will finish the interlocking of the bricks and assist to get rid of any weed growth. Just include yard seed to the outside edges and you should have a stunning entrance to your home within a couple of weeks.


In addition, installing a Brick or Paver sidewalk does not necessarily need a pro. The secret to setting up a Brick or Paver Walkway is to very first effectively prepare the here area where the bricks/pavers are to be set up. Now that you have a steady base, put a 1" pipeline or ledger board the length of the sidewalk on either side of the walkway. These strips will act as your sidewalk border and assistance to keep the integrity and shape of the pathway. Undoubtedly bricks/pavers will need to be cut or split when developing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *